My Routers


Netgear DG834GT

Custom firmware for DG834GT


DGTeam Firmware
DG834GT_V1.02.16_DGTeam_0848   (now obsolete)
I've used v0848 of this firmware for a few month with good results. It's based on netgrears firmware V1.02.16 with many added features, the best being the ability to set your own target noise margin.
A couple of minor problem I've found with this firmware.
1) If  the routers firewall is set to block IM (instant messaging) ports then this also stops large email attachments from being sent. Haven't tested this with Netgears firmware V1.02.16 but it may be the same bug exists with that.
2) The log showed frequent  NTP queries (time sync).

DG834GT - 1.03.22 DGTeam REV. 1014

This has fixed the block IM firewall issue.

There's a choice of three images, each with a different ADSL driver.
adsldrv022c -- oldest driver, still used in Netgear's own firmware
adsldrv023b
adsldrv023o -- newest driver, with impulse noise protection (PhyRe) setting.
I've tested all three on my long line, there was no noticeable difference in performance.

New features include:-
1) Dynamic DNS -- A number of pre-set service providers including OpenDNS.

2) Custom Setup -- Allows running a custom script at system events or at set times.
I use this to reboot the router each morning at 8:57am. Useful if the router has a re sync, to a lower speed, during the night.
ie in "Cron table script" enter the following script:   57 8 * * * root /sbin/reboot
See DGTeam's forum for more information on custom scripts.

3) Wake on Lan. No need to remember the MAC address, they are all show on the page displayed by the router.

GaTi Firmware
GaTi V0.6 Beta1, based on Netgears firmware V1.02.19 again with many extra features. So far I've found no problems sending email attachments with or without IM ports blocked. Time syncs are a more reasonable one per day.

Netgear's Firmware
V 1.02.19 This gave me problems with DHCP. Sometimes when starting a computer it would be given the wrong IP address and the computer would not be able to see the network. Manually setting the IP, Subnet and Gateway addresses in the computer fixed this issue but this should not have been necessary.
Never had this issue using the above GaTi firmware although it is based on Netgear's v 1.02.19.
V 1.03.22  Not tried this firmware.
V 1.03.23  Not tried this firmware.



2Wire BT2700HGV
This was my preferred router for ADSL (up to 8 Meg) connecting to a dslam using a Texas Instruments chipset.
Since moving to a different supplier offering ADSL2+ with a dslam using a Broadcom chipset I find the Speedtouch 858v7 and Netgear DG845GT gives slightly better result.
This router however gave me the best wireless signal of any other I've tried.



Speedtouch TG585 v7
This gave me good sync speed but did suffer from occasional re-boot's, suspected to be due to over heating.
Poor wireless signal.



D-Link DSL-G624T
Worst connection speed of any router I've tried on my line.
Wireless signal was OK.



Thomson TG587n v2
Good connection speed on my long line. Good wireless signal throughout the house at 130 Mbps.
Only thing I can fault is the dreadful user interface.
Learning a few control line interface commands ( cli commands )  issued by telnet is essential.



Home Page

footer
Copyright© NPR 2010 - 2012       Disclaimer